2 - The inside.

    2.1 - Rollbar assembly.

    2.2 - Dashboard.

    2.3 - Seats and belts.

    2.4 - Spare wheel and other details.

2.1 - Rollbar assembly.

You can now start the real assembly with the dashboard, steering wheel, gear lever, handbrake lever, and bench to the bottom.

Don't forget in this fase to make the hole in the bottom, for fixing the model on the base.

Then assemble the rollbar cage, following the instructions sheets, taking care the positions and passages on the inside of the bodyshell.

Start then with painting, first with a primer coat, and then with the given colour paint. Alternatively, the parts in different colours, like the dashboard, can be assembled after painting, letting them be prepared with more attention, especially in 1:24 scale.

2.2 - The dashboard.

Then you can go on with the dashboard details, like decalcomanias and tripmaster photoengravings and buttons.

Finally you can stick it on the bottom, if You haven't already proceeded to before.

2.3 - Seats and belts.

The seat can be painted in many different ways. You can spray them or paint with humbrol. The kevlar or carbon look can be obtained in decal, masking with a piece of clove and paint it silver or using other materials, for example the sheet of paper inside the cigarettes boxs.

Then you can apply the seat brand and driver names decalcomanias. After this you can proceed placing the seat belts, inserting the given photoengravings at the ends, and the locking buckle, leaving them locked or in a more effective way in "open order", don't forgetting to leave the ends long, for attaching them on the rollbar.

Finally you can apply the seat belt decalcomanias and proceed with the sticking on the bottom, always with vinavil, after removing a bit of paint. Stick then the free ends on the rollbar cage.

2.4 - Spare wheel and other details.

Finish the ryms, brake plates and the other pieces. Place the spare wheel with its tie-rods and the remaing details.

You are now free to realize many other details, personalizing your model with sleeve, electrical wires, pipes, clamp, and tie-rods, to make it more real and unique compared to the standard kit.